LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior Trim >> Repair Instructions >> Molding Replacement - Rocker Panel (Utility) >> Removal Procedure

Removal Procedure

  1. Open the front and rear side doors.
  2. Remove the rear door. Refer to DOOR REPLACEMENT - REAR .
    3. Fig 1: Rocker Panel Molding (Utility)
    GM869909Courtesy of GENERAL MOTORS CORP.
  3. Pry with a suitable tool at the rocker panel molding section (2) to release tape.
  4. Pry at sections (4) to release spring clips from the rocker panel molding.
  5. Remove the rocker panel molding (3) from the vehicle.
scientia non olet · About LEMON Manuals