Remote Playback Device - Audio Noise

Step	Action	Yes	No
Schematic Reference: Radio/Audio System Schematics
1	Did you review the Radio/Audio System Description and Operation and perform the necessary inspections?	Go to Step 2	Go to Radio/Audio System Description and Operation
2	Turn ON the ignition, with the engine OFF. Turn ON the radio. Insert a tape, CD, or CD magazine with at least 1 audio CD inside, into the remote playback device. Turn ON the remote playback device. Does the remote playback device operate without audio noise?	Go to TESTING FOR INTERMITTENT AND POOR CONNECTIONS	Go to Step 3
3	Turn OFF the ignition. Disconnect the remote playback device. Test the drain wire circuit of the remote playback device for high resistance or an open. Refer to CIRCUIT TESTING andWIRING REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 4
4	Test the remote playback device audio common signal circuit of the remote playback device for a short, high resistance, or an open. Refer to CIRCUIT TESTING andWIRING REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 5
5	Inspect the audio harness shield of the remote playback device for damage. Refer to CIRCUIT TESTING andWIRING REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 6
6	Inspect for poor connections at the harness connector of the remote playback device. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS and CONNECTOR REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 7
7	Inspect for poor connections at the harness connector of the radio. Refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS and CONNECTOR REPAIRS . Did you find and correct the condition?	Go to Step 9	Go to Step 8
8	Replace the remote playback device. Refer to Remote CD Player Replacement . Did you complete the replacement?	Go to Step 9	-
9	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 2