LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Yukon Denali >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Exterior Lights >> Lighting Systems >> Repair Instructions >> License Lamp Replacement (Escalade EXT) >> Removal Procedure

Removal Procedure

  1. Remove the rear license plate attaching hardware from the rear bumper.
  2. Remove the spare tire wheel hoist guide and retaining clip. Refer to TIRE HOIST AND SHAFT REPLACEMENT .
  3. Remove the top fascia step pads. Refer to STEP PAD REPLACEMENT - TOP REAR BUMPER .
  4. Remove the center fascia step pads. Refer to STEP PAD REPLACEMENT - CENTER REAR BUMPER .
  5. Remove the rear object sensors. Refer to REAR OBJECT SENSOR REPLACEMENT .
    6. Fig 1: Rear Fascia
    G01696805Courtesy of GENERAL MOTORS CORP.
  6. Remove the rear fascia from the bumper bar.
    7. Fig 2: License Lamp Assembly
    G01696806Courtesy of GENERAL MOTORS CORP.
  7. Release the lamp assembly tab from the rear fascia to remove.
  8. Release the lamp socket by turning 1/4 turn counterclockwise.
  9. Remove the lamp assembly from the vehicle.
scientia non olet · About LEMON Manuals