Playing a Compact Disc - Uplevel/Luxury

PWR

1. Press the PWR knob in order to turn the system on.
2. The system can be turned on by inserting a compact disc into the player with the ignition in the ON position.
3. Insert a disc partway into the slot, label side up.
4. The player pulls the disc in.
5. When inserted, the disc will begin playing track 1.
6. Wait a few seconds until the disc plays.
7. The letters "CD" and a CD symbol appears on the display.
8. If the disc comes back out and ERR appears on the display, inspect for the following conditions:
   • The disc is upside down.
   • The disc is dirty, scratched, or wet.
   • There is too much moisture in the air.

     Wait an hour and try again.

   • The vehicle is operating on a very rough road.
   • The disc player is very hot.
9. Press RECALL in order to eliminate the ERR message.

RECALL

1. Press the RECALL button in order to see what track is playing.
2. Press the RECALL button again within 5 seconds in order to see the elapsed time of the current track.
3. The track number appears when a new track begins to play.
4. Press RECALL again in order to return to the time display.

PREV

1. Press PREV or the SEEK left arrow in order to search for the previous selection.
2. If you hold the PREV button or press it more than once, the disc advances further.

RDM

1. The random playback (RDM) feature allows the tracks on the compact disc to be played in random order rather than in sequential order.
2. During random playback, a RANDOM indicator appears in the display.
3. Press RDM again in order to return to normal play.

NEXT

1. Press NEXT or the SEEK right arrow in order to search for the next selection.
2. If you hold the NEXT button or press it more than once, the disc will advance further.
3. The next track number will appears on the display.

REV

1. Press and hold the REV button in order to quickly reverse within a track.
2. When the CD reverses, elapsed time displays in order to find the correct passage.

FWD

1. Press and hold the FWD button in order to quickly advance within a track.
2. When the CD advances, elapsed time displays in order to find the correct passage.

AM-FM

1. While in the CD mode, press the AM-FM button in order to stop playing the CD and play the radio.
2. The CD symbol will still be displayed but the letters CD are replaced with AM, FM1, or FM2.
3. If the radio is turned OFF, the disc will remain in the player and resume playing at the point where it stopped, when the radio is turned ON.

CD AUX

1. Press the CD AUX button in order to return from listening to the radio and play the CD.
2. When a disc plays, the letters "CD" and the CD symbol will appear on the display.
3. If the radio is turned OFF, the disc will remain in the player and resume playing at the point where it stopped, when the radio is turned ON.

EJECT

• Press EJECT in order to eject the disc from the CD player.
• A disc that has been ejected but not removed from the player will be pulled back in within 30 seconds.
• This protects the disc and the player from damage.
• The disc does not play.
• In order to remove the disc, press the EJECT button and remove the disc from the player.