Diagnostic Aids
NOTE:
- Remove any debris from the TAC module connector surfaces before servicing the TAC module. Inspect the TAC module connector gaskets when diagnosing/replacing the module. Ensure that the gaskets are installed correctly.
- For any test that requires probing the PCM or a component harness connector, use a connector test adapter. Using a connector test adapter prevents damage to the harness/component terminals. Refer to USING CONNECTOR TEST ADAPTERS in Wiring Systems.
- Inspect for a set/coast switch stuck in the engaged position or the signal circuit is shorted to voltage.
- For an intermittent, refer to TESTING FOR INTERMITTENT AND POOR CONNECTIONS in Wiring Systems.