LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Replacement (Hydraulic Boost) >> Removal Procedure

Removal Procedure

  1. Apply the park brake and block the wheels.
  2. Disconnect the electrical connector from the brake fluid level sensor.

    Important:  Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.

  3. Disconnect the brake pipes from the master cylinder.
    4. Fig 1: Disconnecting Brake Pipes From Master Cylinder
    G01669030Courtesy of GENERAL MOTORS CORP.
  4. Plug the open brake pipe ends.
  5. Remove the master cylinder mounting nuts.
  6. Remove the master cylinder from the vehicle.
  7. Remove the master cylinder reservoir. Refer to Master Cylinder Reservoir Replacement .
scientia non olet · About LEMON Manuals