Installation Procedure
- Install new anti-rattle clips to the brake caliper mounting bracket.
- Install the disc brake pads to the brake caliper mounting bracket.
- Install the inner pad, 1 wear indicator.
- Install the outer pad, 2 wear indicators
- Install the brake caliper. Refer to Front Brake Caliper Replacement
- Install the tire and wheel assembly.
- Remove the safety stands.
- Lower the vehicle.
- With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
- Slowly release the brake pedal.
- Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
- Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to MASTER CYLINDER RESERVOIR FILLING in Hydraulic Brakes.
- Burnish the disc brake pads and rotors. Refer to Brake Pad and Rotor Burnishing