LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes (Cab & Chassis, & Hd) >> Removal & Installation >> Brake Pedal Assembly >> Removal

Brake Pedal Assembly: Removal

  1. Remove the pushrod retainer from the brake pedal pin. See Fig 1 .
  2. Remove the stop light switch from the brake pedal pushrod pin.
  3. Remove the pushrod from the brake pedal pin.
  4. Remove the bolts that retain the instrument panel center support bracket to the steering column bracket. See Fig 2 .
  5. Remove the bolt that retains the reinforcement to the instrument panel center support bracket.
  6. Disconnect the electrical connector from the remote control door lock receiver.
  7. Remove the instrument panel center support bracket.
  8. Remove the brake pedal nut. See Fig 3 .
  9. Remove the brake pedal bolt.
  10. Remove the brake pedal.
  11. Remove the bushings and the spacer from the brake pedal.
Fig 1: Removing Pushrod Retainer
G00317528Courtesy of GENERAL MOTORS CORP.
Fig 2: Removing Instrument Panel Center Support Bracket
G00317529Courtesy of GENERAL MOTORS CORP.
Fig 3: Removing Pedal Nut & Bolt
G00317530Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals