Installation Procedure

Install the lower I/P trim panel to the I/P assembly.
Connect the following electrical components:
- The power outlet ports (1, 2)
- The ashtray lamp (3)
- The I/P compartment lamp, if equipped
Install the screws connecting the lower trim panel to the I/P assembly. Tighten the screws to 2 N.m (18 lb in).
Install the following components, depending on how equipped:
- The I/P cupholder cover, shown
- The I/P cupholder
  Refer to Cupholder Replacement (Except Pro) or Cupholder Replacement (Pro) .
- The floor console extension
  Refer to Console Replacement (Luxury Console) , Console Replacement (Base Console) or Console Replacement (Pro) .
Install the I/P cluster trim bezel. Refer to Instrument Panel Cluster (IPC) Replacement .