Electric Auto/Apply System
WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 1998 Pontiac Trans Sport, 1998 Oldsmobile Silhouette, 1998 Oldsmobile Bravada, 1998 GMC Yukon, and 1998 GMC Suburban. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure shift lever is in Park, and manual parking brake is set. Loosen adjusting rod jam nuts. Rotate rod until hole in switch cam aligns with hole in bracket. Insert 3/8" (9.5 mm) pin through switch cam and bracket. See Fig 1. Tighten jam nuts.
- Loosen cam actuated switch jam nuts. Adjust switch so plunger contacts clevis pin and clevis pin contacts cam assembly. DO NOT compress switch plunger more than .020" (.5 mm). Tighten jam nuts and remove pin. Check parking brake operation and holding ability. Repeat procedure if necessary.