LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Pipe >> Installation

Brake Pipe: Installation

  1. Bend the brake pipe to achieve proper fit.
  2. Install the brake pipe to the vehicle. Maintain a clearance of 3/4 in (19 mm) for all moving or vibrating components.
  3. Install the brake pipe fasteners to the vehicle.
  4. Connect the brake pipe fittings. Tighten the brake pipe fittings to the BPMV or the wheel jounce hoses to specification. See TORQUE SPECIFICATIONS . Tighten the brake pipe fittings to the master cylinder to specification. See TORQUE SPECIFICATIONS .
  5. Bleed the hydraulic brake system. Refer to one of the following procedures: If the brake pipe that was replaced was between the master cylinder and the BPMV, see appropriate ANTI-LOCK article. If the brake pipe that was replaced was between the BPMV and the wheel jounce hoses, see HYDRAULIC BRAKE SYSTEM - MANUAL  or HYDRAULIC BRAKE SYSTEM - PRESSURE  under BLEEDING.
scientia non olet · About LEMON Manuals