LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Brake Hose - Front Dual Piston Caliper >> Installation

Brake Hose - Front Dual Piston Caliper: Installation

  1. Install the copper gaskets on the brake hose bolt.
  2. Install the front brake hose to brake caliper. Tighten the front brake hose bolt to specification. See TORQUE SPECIFICATIONS .
  3. Remove the rubber cap or plug from the brake pipe fitting.
  4. Install the brake hose to the brake pipe.
  5. Using a backup wrench, tighten the brake hose and the brake pipe fitting. Tighten brake hose fitting to specification. See TORQUE SPECIFICATIONS .
  6. Install the brake hose retaining bracket to the upper control arm.
  7. Install the brake hose retaining bracket bolt and nut. Tighten Brake hose retaining bracket nut to specification. See TORQUE SPECIFICATIONS .
  8. Install the brake hose retaining clip at the frame.
  9. Bleed the hydraulic system. See HYDRAULIC BRAKE SYSTEM - MANUAL  or HYDRAULIC BRAKE SYSTEM - PRESSURE  under BLEEDING.
  10. Install the tire and wheel assembly. See TORQUE SPECIFICATIONS .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals