LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Adjusting Screw Replacement >> Removal

Adjusting Screw Replacement: Removal

  1. Raise the vehicle.
  2. Remove the tire and wheel assembly.
  3. Remove the brake drum. See BRAKE DRUM REPLACEMENT .
  4. Remove the brake shoe return springs.
  5. Remove the brake shoe guide.
  6. Remove the hold down springs.
  7. Remove the hold down pins.
  8. Remove the actuator lever and the actuator lever pivot.
  9. Remove the actuator lever and the lever pivot.
  10. Remove the lever return spring.
  11. Remove the park brake strut and the strut spring.
  12. Remove the adjusting screw assembly and the adjusting screw spring from the brake shoes.
  13. Inspect all remaining parts for discoloration due to heat or stress. Replace parts as needed. See Fig 1.
Fig 1: Exploded View Of Rear Brake Shoe Assembly
G95H27109Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals