Stoplight Switch: Installation
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Install the stoplight switch into the slotted grooves until switch is fully depressed against the brake pedal, then turn the switch clockwise approximately 1/4 turn, the switch should now be installed and adjusted. See Fig 1.
- Connect the electrical connectors.
- Install the left side instrument panel insulator.
- If necessary, adjust the stoplight switch. See STOPLIGHT SWITCH under ADJUSTMENTS & INSPECTION.