LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Envoy RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 355 (Engine Mechanical - 3.1L V6 - VIN (J) (On-Vehicle)) >> Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine oil pressure sensor.

    Tighten: 

    Tighten the sensor to 16 N.m (12 ft lbs) 

  2. Connect the engine oil pressure sensor electrical connector.
  3. Lower the vehicle.
  4. Check and fill the crankcase as necessary. Refer to Engine Oil and Oil Filter Replacement .
scientia non olet · About LEMON Manuals