LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Envoy RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1102 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Engine Mount Strut Bracket Replacement - Upper Radiator Support >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Engine Mount Strut Bracket Bolts
    GM61851Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount strut bracket over the upper radiator support. Ensure that the engine mount strut bracket and the engine mount strut are aligned to the proper holes of the upper radiator support.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the engine mount strut bracket bolts to the upper radiator support.

    Tighten:  Tighten the engine mount strut bracket bolts to 26 N.m (19 lb ft).

    3. Fig 2: View Of Bolt & Nut For Engine Mount Strut At Engine Mount Strut Bracket On Upper Radiator Support
    GM61850Courtesy of GENERAL MOTORS CORP.
  3. Install the engine mount strut to the engine mount strut bracket at the upper radiator support. Refer to Engine Mount Strut Replacement - Left  and/or Engine Mount Strut Replacement - Right .
scientia non olet · About LEMON Manuals