LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Envoy RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1102 (Engine Mechanical (Repair Instructions 1 Of 5) - 3.6L (Ly7)) >> Repair Instructions (On-Vehicle Part 1) >> Engine Mount Strut Bracket Replacement - Left >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the left engine mount strut bracket and bolts to the vehicle.
    2. Fig 1: View Of Engine Mount Strut Bracket Bolts
    GM1457530Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Connect the engine mount strut bracket bolts to the cylinder head.

    Tighten:  Tighten the engine mount strut bracket bolts to 50 N.m (37 lb ft).

    3. Fig 2: Identifying Exhaust Crossover Pipe Nuts & Studs
    GM1395470Courtesy of GENERAL MOTORS CORP.
  3. Install the exhaust crossover pipe nuts (5) and studs (1).

    Tighten:  Tighten the exhaust crossover pipe nuts (5) to 34 N.m (25 lb ft).

  4. Connect the PCV tube to the air intake duct.
  5. Install the left engine mount strut to the left engine mount strut bracket. Refer to Engine Mount Strut Replacement - Left .
scientia non olet · About LEMON Manuals