LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1688 (Disc Brakes (Except Cab & Chassis, & Hd)) >> Repair Instructions >> Rear Disc Brake Pads Replacement (All except 1500 Series W/O 4-Wheel Steering) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
GM369668
  1. Install the anti-rattle clips to the brake caliper mounting bracket
  2. Install the disc brake pads to the brake caliper mounting bracket
  3. Install the brake caliper to the brake caliper mounting bracket. Refer to Rear Brake Caliper Replacement (1500 Series)  or Rear Brake Caliper Replacement (2500/3500 Series) 
  4. Install the tire and wheel assembly
  5. Remove the safety stands
  6. Lower the vehicle.
  7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance
  8. Slowly release the brake pedal
  9. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads
  10. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to MASTER CYLINDER RESERVOIR FILLING in Hydraulic Brakes
  11. Burnish the brakes pads and rotors as necessary. Refer to Brake Pad and Rotor Burnishing 
scientia non olet · About LEMON Manuals