Assembly Procedure
WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the brake caliper bleed screw. Tighten the brake caliper bleed screw to 12 N.m (106 lb in).
- Install the brake caliper bleed screw cap
- Lubricate the new piston seal and the brake caliper bore seal groove with brake fluid
- Install the new seal into the brake caliper bore seal groove.
- Ensure that the seal is not twisted.
- Lubricate the brake caliper bore and the piston with brake fluid
- Install the boot and piston
- 7.1. Install the boot over the end of the piston so that the fold will face toward the brake caliper housing piston bore opening
- 7.2. Seat the boot into the brake caliper bore groove. Slide the piston into the brake caliper bore
- 7.3. Push down the piston to the bottom of the brake caliper bore
- 7.4. Ensure that the boot is properly seats into the piston groove and into the groove in the brake caliper bore
- Install the brake caliper to the vehicle. Refer to Rear Brake Caliper Replacement (1500 Series) or Rear Brake Caliper Replacement (2500/3500 Series)