LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1688 (Disc Brakes (Except Cab & Chassis, & Hd)) >> Repair Instructions >> Rear Brake Caliper Bracket Replacement (15/25 Series) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel assembly
    NOTE: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and in turn may cause a brake fluid leak
  3. Remove the brake caliper from the brake caliper mounting bracket and support the brake caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake hose from the brake caliper. Refer to Rear Brake Caliper Replacement (1500 Series)  or Rear Brake Caliper Replacement (2500/3500 Series) 
    4. Fig 1: View Of Disc Brake Pads & Brake Caliper Mounting Bracket
    GM369668
  4. Remove the brake pads from the brake caliper mounting bracket
  5. Remove the anti-rattle clips from the brake caliper bracket
    6. Fig 2: View Of Disc Brake Hardware & Caliper Bracket Bolts
    GM177036
  6. Remove the brake caliper bracket mounting bolts (2).
  7. Remove the brake caliper bracket (1).
  8. Remove any contaminants or foreign material from the inside ends of the brake caliper bracket
  9. Clean the mounting surface and threads of the brake caliper bracket
scientia non olet · About LEMON Manuals