LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> C3500 HD 8.1 G, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1688 (Disc Brakes (Except Cab & Chassis, & Hd)) >> Repair Instructions >> Rear Brake Backing Plate Replacement (15 Series W/NYS - 4-Wheel Steering) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 GMC Sierra and 2002 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the park brake actuator lever housing to the backing plate
  2. Install the park brake shoe.
  3. Install the wheel bearing and adjust the park brake shoe. Refer to WHEEL HUB & BEARING REPLACEMENT in Rear Wheel Steering and Parking Brake Adjustment 
    4. Fig 1: View Of Park Brake Cable To Park Brake Actuator Lever
    GM791352
  4. Install the park brake cable to the park brake actuator lever
    Fig 2: Identifying Rear Park Brake Bracket Bolt
    GM791353
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems
  5. Install the rear park brake bracket bolt. Tighten the bolt to 61 N.m (45 lb ft).
    6. Fig 3: Equalizer Bar & Park Brake Cable - Rear
    GM791349
  6. Install the park brake cable to the equalizer bar
  7. Install the tire and wheel assembly
  8. Lower the vehicle
scientia non olet · About LEMON Manuals