LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Brake Hose Replacement - Rear (Caliper) >> Installation Procedure

Installation Procedure

    IMPORTANT: Install 2 New copper brake hose gaskets.
  1. Assemble the 2 New copper brake hose gaskets and the brake hose bolt to the brake hose.
    2. Fig 1: Brake Hose, Brake Caliper & Gaskets
    GM156274Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the brake hose to caliper bolt and 2 New washers to the brake caliper.

    Tighten:  Tighten the bolt to 40 N.m (30 lb ft).

    3. IMPORTANT: The hose must not be twisted. Make sure the hose is not in contact with any suspension component.
  3. With the weight of the vehicle on the suspension, install the brake hose into the bracket.
  4. Install the brake hose retaining clip to the hose mounting bracket.
  5. Remove the rubber cap or plug from the exposed brake pipe fitting end.
  6. Connect the brake pipe fitting nut to the brake hose:
    • Use a backup wrench on the hose fitting.
    • Do not bend the bracket or the pipe.

      Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  7. Ensure that the hose does not make contact with any part of the suspension. If the hose makes contact, remove the hose and correct the condition.
  8. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual)  or Hydraulic Brake System Bleeding (Pressure) .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals