Parking Brake Warning Switch: Service and Repair

Park Brake Warning Lamp Switch Replacement

Removal Procedure





1. Remove the park brake warning lamp switch electrical connector.
2. Remove the retainer from the switch.
3. Remove the park brake indicator switch (1) from the vehicle.

Installation Procedure





1. Install the park brake indicator switch (1) to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the retaining screw.
^ Tighten the retaining screw to 4 Nm (35 inch lbs.).
3. Install the park brake indicator switch electrical connector.