Enabling

1. Remove the key from the ignition.
2. Connect the IP module yellow 2-way connector (1) located under the instrument panel extension.
3. Install the Connector Position Assurance (CPA) (2) to the IP module yellow 2-way connector (1) located under the instrument panel extension.
4. Install the instrument panel extension.




5. Connect the steering wheel module yellow 2-way connector (1) located at the base of the steering column.
6. Install the CPA to the steering wheel module yellow 2-way connector (1) located at the base of the steering column.
7. Install the sound insulator (if equipped).
8. Install the AIR BAG Fuse to the IP fuse block.
9. Staying well away from the air bags, turn ON the ignition, with the engine OFF.
^ The AIR BAG indicator will flash 7 times.
^ The AIR BAG indicator will then turn OFF.
10. Perform Diagnostic System Check - SIR if the AIR BAG indicator does not operate as described. Diagnostic System Check