Instrument Panel (IP) - Assist Handle Replacement

REMOVAL PROCEDURE




1. Remove the inflatable restraint IP module. Refer to Inflatable Restraint Instrument Panel Module Replacement in Restraint Systems.
2. Remove the nuts from the assist handle.
3. Remove the assist handle.

INSTALLATION PROCEDURE




1. Install the assist handle to the instrument panel.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the assist handle nuts.

Tighten
Tighten the assist handle nuts to 8 N.m (71 lb ft).

3. Install the inflatable restraint IP module. Refer to Inflatable Restraint Instrument Panel Module Replacement in Restraint Systems.