LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> C3500 HD 8.1 G, Standard >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Electronic Suspension - Suspension Damping & Automatic Level Control >> Repair Instructions >> Electronic Suspension Rear Position Sensor Link Assembly Replacement >> Removal Procedure

Removal Procedure

    IMPORTANT:

    Do not attempt to pry the link rod from the real time damping (RTD) ball stud. If the link rod needs to be replaced or disconnected you must use the following procedure.

  1. Remove the RTD sensor from the vehicle. Refer to Electronic Suspension Rear Position Sensor Replacement - Left Side (15 Series) , Electronic Suspension Rear Position Sensor Replacement - Left Side (25 Series) , or Electronic Suspension Rear Position Sensor Replacement - Right Side (25 Series) .
  2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
  3. Remove the link rod from the frame bracket ball stud.
scientia non olet · About LEMON Manuals