Installation Procedure
- Install the module to the vehicle by sliding the module into the bracket.
- Refer to Fastener Notice
in Cautions and Notices.
Install the screw.
Tighten
Tighten the screw to 1.6 N.m (14 lb in).
- Connect the electrical connectors to the module.
- Install the right side interior trim panel. Refer to Rear Quarter Trim Panel Replacement (Utility Left) , Rear Quarter Trim Panel Replacement (Suburban Right) , Rear Quarter Trim Panel Replacement (Utility Right) , Rear Quarter Trim Panel Replacement (Suburban Left) in Interior Trim.