Cycle Outputs
A scan tool may be used in order to command the shock solenoids, leveling compressor, EVO solenoid and SERVICE RIDE CONTROL message ON or OFF. This can be very helpful in determining if a certain portion of a circuit or a component is in working order. The following tests are available under the Special Functions selection. The following can be commanded ON or OFF:
- EVO actuator
- Exhaust
- Compressor
- RTD solenoids
- SERVICE RIDE CONTROL message
RTD Scan Tool Data List
| Scan Tool Parameter | Data List | Units Displayed | Typical Data Value |
|---|---|---|---|
| Park brake set with the ignition switch ON / Ignition Switch in RUN / Engine running / Automatic Transmission in PARK / Air Conditioning is OFF | |||
| Battery Voltage | Data | Volts | 12.0 - 14.7 Volts (varies with the vehicle) |
| Compress Relay Enable | Data | ON/OFF | OFF |
| EVO Actuator Desired @ 0 MPH | Data | ma | 0 |
| EVO Actuator Actual @ 0 MPH | Data | ma | 0 |
| EVO Actuator Desired @ 65 MPH | Data | ma | 0 |
| EVO Actuator Actual @ 65 MPH | Data | ma | 0 |
| Exhaust Signal | Data | ON/OFF | OFF |
| Ignition 3 Voltage | Data | Volts | 12.0 - 14.7 Volts (varies with the vehicle) |
| RTD Air Pressure Sensor | Data | Volts | 0.15 to 4.85 |
| RTD Module ID | Data | - | Varies with the vehicle |
| RTD Position Sensor LF | Data | Volts | 0.5 to 4.85 |
| RTD Position Sensor LR | Data | Volts | 0.5 to 4.85 |
| RTD Position Sensor RF | Data | Volts | 0.5 to 4.85 |
| RTD Position Sensor RR | Data | Volts | 0.5 to 4.85 |
| (RTD) SERVICE RIDE CONTROL message | Outputs | ON/OFF | OFF |
| RTD Solenoid LF | Data | ON/OFF | OFF |
| RTD Solenoid LR | Data | ON/OFF | OFF |
| RTD Solenoid RF | Data | ON/OFF | OFF |
| RTD Solenoid RR | Data | ON/OFF | OFF |
| Sensor Supply Voltage | Data | Volts | 4.8 to 5.2 |
| Steering Position Sensor 1 | Data | Volts | 0.35 to 4.7 |
| Steering Position Sensor 2 | Data | Volts | 0.35 to 4.7 |
| Vehicle Speed | Data | MPH | 0 |