Scan Tool Data Definitions: Data

Battery Voltage - Range: 10.0-16.0 Volts: This data refers to the battery system voltage as measured by the suspension control module.
Compressor Signal control - Range: ON/OFF: This data refers to the state of the compressor motor relay.
EVO Actuator Desired- Range: counts/Percent: This data is what the suspension control module is trying to achieve.
EVO Actuator Actual- Range: Counts/Percent: This data is the actual value of the actuator.
Exhaust Signal control - Range: ON/OFF: This data refers to the state of the exhaust solenoid.
Ignition 3 voltage - Range: 10.0-16.0 volts: This is the ignition voltage as measured by the suspension control module.
RTD Air Leveling Pressure Sensor- Range: 0.15-4.85 volts: This data refers to the air within the rear leveling shocks measured in volts.
RTD Indicator - Range: ON/OFF: This data refers to the request by the suspension control module to I/P cluster for the message.
RTD Position Sensor (body-to-wheel) - LF, RF, LR, and RR - Range: 0.35-4.75 volts: This data refers to the vehicle height measured in volts.
RTD Solenoid (shock) - LF, RF, LR, and RR - Range: Percent (ON/OFF): This data refers to the state of solenoid contained within the shock.
Steering Position Sensor 1 signal - Range: 0.35-4.7 volts: This data is the position of the steering wheel measured in volts.
Steering Position Sensor 2 signal - Range: 0.35-4.7 volts: This data is the position of the steering wheel measured in volts.
Vehicle Speed - Range: 0 -193 km/h (0-120 mph): This is the suspension control module measurement of the vehicle's speed from a discrete output from the powertrain control module (PCM).