LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> C3500 HD 8.1 G, Standard >> Repair and Diagnosis >> Suspension >> Electronic Suspension >> Electronic Suspension - Suspension Damping & Automatic Level Control >> Diagnostic Information and Procedures >> DTC C0550 >> Test Description

Test Description

The number(s) below refer to the step number(s) on the diagnostic table.

  1. 2 

    Checking to verify the DTC will not reset.

  2. 3 

    Replace the suspension control module and re-calibrate.

DTC C0550

Step Action Yes No
Schematic Reference: Suspension Controls Schematics 
1 Did you perform the RTD Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Real Time Damping 
2 
  1. Use the scan tool in order to clear the DTCs.
    IMPORTANT:

    Use the scan tool to perform the set up procedure (re-calibrate) located under Special Functions (F8: Recalibration) for the suspension control module.

  2. Turn OFF the ignition and wait 45 seconds.
  3. Turn ON the ignition, with the engine OFF.
  4. Select the Suspension Control Module display DTCs function on the scan tool.
Does the scan tool display DTC C0550?		 Go to Step 3  Go to Diagnostic System Check - Real Time Damping 
3 
IMPORTANT:

After replacement, use the scan tool to perform the set up procedure (re-calibrate) located under Special Functions (F8: Recalibration) for the suspension control module.

Replace the suspension control module. Refer to Electronic Suspension Control Module Replacement (Suburban/Yukon XL) , Electronic Suspension Control Module Replacement (Tahoe/Yukon) .Did you complete the replacement?		 System OK -
scientia non olet · About LEMON Manuals