LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> C3500 HD 8.1 G, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Steering Column Switches >> Steering Wheel And Steering Column - Tilt >> Repair Instructions >> Lower Intermediate Steering Shaft Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Lower Shaft To Upper Shaft Bolt
    GM362505Courtesy of GENERAL MOTORS COMPANY
  1. Install the upper end of the intermediate shaft into the upper shaft.
  2. Install the lower end of the intermediate shaft coupler.
    1. If you are reinstalling the same shaft, align the marks made during the removal procedure.
    2. Install the lower end of the intermediate shaft coupler onto the steering gear worm shaft.
  3. Install the bolt to the lower shaft coupler.
  4. Refer to Fastener Notice .

    Install the bolt to the upper end of the shaft.

    Tighten 

    • Tighten the upper bolt to 47 N.m (35 lb ft).
    • Tighten the coupler pinch bolt to 50 N.m (37 lb ft).
  5. For vehicles equipped with a 6.6L Diesel, install the left charge air cooler hose. Refer to Charge Air Cooler Inlet and Outlet Duct Replacement in Engine Mechanical - 6.6L.
    6. Fig 2: Locking/Unlocking Steering Column
    GM333146Courtesy of GENERAL MOTORS COMPANY
  6. Remove the J 42640  from the steering column lower access hole.
scientia non olet · About LEMON Manuals