Selectable Ride Indicator Lamp Does Not Light

Step	Action	Yes	No
Schematic Reference: Suspension Controls Schematics
1	Did you review the system circuit description and perform the necessary inspections?	Go to Step 2	Go to Symptoms - Selectable Ride
2	Verify the fault is present. Does the system operate normally?	Go to Testing for Electrical Intermittents in Wiring Systems	Go to Step 3
3	Remove the selectable ride switch from the instrument panel. Refer to Electronic Suspension Switch Replacement . Turn ON the ignition, with the engine OFF. Ensure the selectable ride switch is in the ON, (FIRM) position. Connect a test lamp (back probe), between the selectable ride switch control circuit and a good ground. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate?	Go to Step 5	Go to Step 4
4	Connect a test lamp (back probe), between the ignition 1 voltage circuit and a good ground. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate?	Go to Step 8	Go to Step 6
5	Turn OFF the ignition . Disconnect the selectable ride switch. Connect a test lamp between the selectable ride switch ground circuit and a battery positive voltage (B+) circuit. Refer to Circuit Testing in Wiring Systems. Does the test lamp illuminate?	Go to Step 6	Go to Step 7
6	Repair the open in the ignition 1 voltage circuit between the selectable ride switch and Body Wiring Harness Junction Block. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair?	Go to Step 9	-
7	Repair the open selectable ride switch ground circuit. Refer to Wiring Repairs in Wiring Systems. Did you complete the repair?	Go to Step 9	-
8	Replace the selectable ride switch. Refer to Electronic Suspension Switch Replacement . Did you complete the replacement?	Go to Step 9	-
9	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3