Cargo Lamp On Indicator Always On

Step	Action	Yes	No
Schematic Reference: Interior Lights Schematics (Base Utility) , Interior Lights Schematics (Base Pickup) , Interior Lights Schematics (Uplevel Pickup) , Interior Lights Schematics (Uplevel and Luxury (Y91) Utility)
1	Did you perform the Lighting Diagnostic System Check?	Go to Step 2	Go to Diagnostic System Check - Lighting Systems
2	Operate the cargo lamps to verify the fault is present. Does the system operate normally?	Go to Testing for Electrical Intermittents in Wiring Systems	Go to Step 3
3	Turn ON the cargo lamp switch. Open the LF door. Close the LF door. Does the cargo lamp function properly?	Go to Step 4	Go to Cargo Lamp Always On , or Cargo Lamp Inoperative
4	Turn ON the ignition with the engine OFF. Use the scan tool in order to select IPC, Special Functions, and command the Cargo Lamp On message OFF and ON. Does the message turn on and off when commanded?	Go to Step 7	Go to Step 5
5	Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections , and Connector Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 7	Go to Step 6
6	Replace the IPC. Refer to Instrument Cluster Replacement in Instrument Panel, Gauges, and Console. Did you complete the replacement?	Go to Step 7	-
7	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3