LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2001 >> C3500 HD 6.5 F, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Instrument Panel Upper Trim Pad Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Ambient Light Sensor Electrical Connector
    GM350507Courtesy of GENERAL MOTORS COMPANY
  1. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim pad.
    2. Fig 2: Identifying I/P Assembly Upper Trim Panel
    GM348717Courtesy of GENERAL MOTORS COMPANY
  2. Install the trim pad to the IP assembly.
  3. Refer to FASTENER NOTICE in Cautions and Notices.

    Install the trim pad retaining screws.

    Tighten 

    Tighten the trim pad retaining screws to 2 N.m (18 lb in).

  4. Install the windshield pillar garnish moldings. Refer to Windshield Pillar Garnish Molding Replacement in Interior Trim.
    5. Fig 3: View Of Assist Handle
    GM348728Courtesy of GENERAL MOTORS COMPANY
  5. Align the assist handle with the holes in the IP assembly. Push the handle in order to engage the retaining tabs.
  6. Install the right side air outlets.
    7. Fig 4: View Of End Panel
    GM348724Courtesy of GENERAL MOTORS COMPANY
  7. Install the end panels. Left is shown, right is similar.
  8. Install the IP cluster trim plate bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
  9. Tilt the steering wheel to the normal driving position.
  10. If the transmission is automatic, move the shift lever to the park position.
  11. Disengage the parking brake.
scientia non olet · About LEMON Manuals