Installation Procedure
- Refer to Fastener Notice
in Cautions and Notices.
Install the DIC and power outlet bracket to IP extension.
Tighten
Tighten the bracket screws to 1.6 N.m (14 lb in).
- Install the speaker. Refer to Radio Front Floor Console Speaker Replacement (Tweeter) .
- Install the extension to the IP.
- Install the 4 retaining screws.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
- Connect the wire connector and attach to the extension.
- Carefully move the console forward to attach to the extension.
- Install the console to the extension by slightly lifting up over the extension hooks and then downwards.
- Install the 2 retaining screws.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
- Connect the wire connectors and attach to the console to prevent rattling during vehicle movement.
- Install the bolts retaining the console to the mounting bracket.
Tighten
Tighten the bolts to 3.5 N.m (31 lb in).
- Install the amplifier, if equipped. Refer to Radio Speaker Amplifier Replacement (Denali Yukon) , Radio Speaker Amplifier Replacement (Base) , Radio Speaker Amplifier Replacement (Denali Suburban) in Entertainment.
- Install the console bin. Refer to Front Floor Console Compartment Replacement (Non-Luxury) .
- Install the CD player. Refer to Remote Compact Disc Player Replacement .
- Install the DIC. Refer to Driver Information Center Replacement .
- Install the console bezel. Refer to Floor Console Bezel Replacement (Luxury) .
IMPORTANT:
Verify that the wire or connector is NOT outside the console.