Removal Procedure
IMPORTANT:
This procedure calls for the replacement of incandescent bulbs only. The light emitting diodes (LEDs) are not replaceable individually. If LED or soldered-in incandescent bulb replacement is needed, send the cluster to an AC Delco Service Center. Refer to Instrument Cluster Replacement .
- Remove the instrument panel (I/P) cluster. Refer to Instrument Cluster Replacement .
- Unclip the I/P cluster rear cover plate by prying gently on the tabs with a screwdriver.
- Remove the rear cover plate from the I/P cluster.
- Remove the bulb and base assembly by turning the bulb 1/2 turn counter clockwise and pulling outward.
- Remove the bulb from the base by pulling outward.