LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Savana G2500, Van Cargo Extended, 5.0 M >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Engine Mechanical (Repair Instructions 3 Of 5) - 3.6L (Ly7)) >> Repair Instructions (Off-Vehicle Repair Instructions - Part 2) >> Crankshaft Rear Oil Seal and Housing Removal

Crankshaft Rear Oil Seal and Housing Removal

WARNING: This page is about a different car, the 2004 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Crankshaft Rear Oil Seal Housing Bolts
    GM1306175Courtesy of GENERAL MOTORS CORP.
  1. Remove the crankshaft rear oil seal housing bolts.
    2. Fig 2: Identifying Pry Points On Edge Of The Crankshaft Rear Oil Seal Housing
    GM1492611Courtesy of GENERAL MOTORS CORP.
  2. Using the pry points located at the edge of the crankshaft rear oil seal housing shear the RTV sealant.
    3. Fig 3: View Of Crankshaft Rear Oil Seal Housing
    GM1306173Courtesy of GENERAL MOTORS CORP.
  3. Remove and discard the crankshaft rear oil seal housing.
scientia non olet · About LEMON Manuals