LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Savana G2500, Van Cargo Extended, 5.0 M >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Front Suspension System) >> Removal & Installation >> Hub & Bearing Assembly >> Removal

Hub & Bearing Assembly: Removal

WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support vehicle by frame. Remove wheel. Clean and lubricate axle shaft threads, insert punch or screwdriver between caliper and rotor to hold rotor from turning. Remove axle shaft nut. Remove caliper, and wire aside. Remove rotor. Disconnect wheel speed sensor. See Figure .
  2. Remove hub retaining bolts and dust shield. Ensure transmission is in Park. Separate hub and bearing from axle shaft using Front Hub Spindle Remover (J-28733).
scientia non olet · About LEMON Manuals