LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Savana G2500, Van Cargo Extended, 5.0 M >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Engine Mechanical - 3.0L) >> Removal & Installation >> Front Oil Pump Seal >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 Saturn Vue and 2002 Saturn Vue. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove front cover. See FRONT COVER & OIL PUMP . Remove the timing belt. See TIMING BELT & GEARS . Remove crankshaft drive gear. See OIL PUMP .
  2. Carefully drill a small, shallow pilot hole into the steel ring of the seal. Use caution when drilling the hole so as not to damage the area around and behind the seal. Screw in a self tapping screw. Use pliers to pull out the front main oil seal. Clean all sealing surfaces.
  3. Coat the lip of the front main oil seal with a small amount of clean engine oil to aid in the installation. Using Crankshaft Front Main Seal Installer (J-35268A), install the front oil pump seal. Ensure that the front oil pump seal is fully and evenly seated.
  4. To complete installation, reverse removal procedure. Tighten all fasteners to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals