LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Savana G2500, Van Cargo Extended, 5.0 M >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Anti-Theft System) >> Diagnostic Tests >> DTC B3033: System Indicates Tamper >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2000 GMC Yukon XL, 2000 GMC Yukon, 2000 GMC Sierra, 2000 Chevrolet Tahoe, and 2000 Chevrolet Suburban. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition on. Using scan tool, clear DTCs. Turn ignition off. Turn ignition on. If DTC B3033 resets, go to next step. If DTC B3033 does not reset, check for intermittents and poor connections. See DIAGNOSTIC AIDS  .
  2. Inspect area around ignition lock cylinder for any device which could create a magnetic field. Repair as necessary. If there are no magnetic devices around ignition lock cylinder, go to next step.
  3. Check mechanical operation of ignition switch. If there is binding or damage, replace ignition switch. If no problem exists, go to next step.
  4. Replace Passlock(tm) sensor. See PASSLOCK(tm) LOCK CYLINDER  under REMOVAL & INSTALLATION. Perform auto learn procedure. See PROGRAMMING  . If DTC still exists, go to next step. If DTC does not exist, go to step  6 .
  5. Replace BCM. See BODY CONTROL MODULE  under REMOVAL & INSTALLATION. After repairs, go to next step.
  6. Reconnect all connectors. Turn ignition on. Using scan tool, clear all DTCs. Perform auto learn procedure. See PROGRAMMING  .
scientia non olet · About LEMON Manuals