LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Safari Van Cargo, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 484 (Disc Brakes & Drum Brakes) >> Removal & Installation >> Park Brake Cable - Rear 4WD Pickups And Utilities >> Removal

Park Brake Cable - Rear 4WD Pickups And Utilities: Removal

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the park brake, if applied.
  2. Raise and support the vehicle.
  3. Loosen the front cable at the equalizer.
  4. Using the Park Brake Cable Release Tool (J-37043), collapse the locking finger for the rear park brake cable.
  5. Remove the rear park brake cable from the connector.
  6. Remove the rear park brake cable from the equalizer.
  7. Using the release tool, collapse the locking finger for the rear park brake cable.
  8. Slide the inner park brake cable rearward.
  9. Remove the park brake cable from the frame retainers.
  10. Remove the park brake cable from the rear axle housing retainers, if needed.
  11. Remove the park brake cable from the park brake actuator.
  12. Using the release tool, collapse the locking tabs on the park brake cable.
  13. Remove the park brake cable release tool from the park brake cable.
  14. Remove the park brake cable from the rear brake cable bracket.
scientia non olet · About LEMON Manuals