Removal & Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
- Pull instrument panel radio trim plate to rear and disengage clips and remove trim plate. Remove 2 screws for console trim plate from just below radio. Pull up on rear of trim plate to disengage retaining clips. Disconnect harness connectors and remove console trim plate. Remove screws from console compartment tray and pull to rear. Disconnect harness connector from cigarette lighter. Remove left and right console side trim panels by sliding them to rear of vehicle to disengage clips. Remove shifter cable. Remove shift park/lock cable.
- Remove main wiring harness connector from console. Open glove box and remove console bolt. Remove bolt from left side of console and 2 nuts from just above radio. Remove 2 screws going into floor at about middle of console. Move front seats forward and remove 2 screws from each side of console at rear. Carefully slide console to rear and lift up to remove from vehicle. To install, reverse removal procedure.