LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Jimmy 2D Utility, RWD, Automatic >> Repair and Diagnosis >> Electrical >> Gauges >> Analog Instrument Panels >> Symptom Tests >> Instrument Panel Cluster (IPC) Inoperative

Instrument Panel Cluster (IPC) Inoperative

NOTE: After each repair procedure has been completed, reconnect all components. Perform INSTRUMENT PANEL CLUSTER (IPC) SYSTEM CHECK  under SYSTEM TESTS.
  1. Perform INSTRUMENT PANEL CLUSTER (IPC) SYSTEM CHECK  under SYSTEM TESTS. Go to next step.
  2. Disconnect IPC connector. Remove instrument cluster as necessary for access to IPC connector. See INSTRUMENT PANEL CLUSTER (IPC)  under REMOVAL & INSTALLATION. Using a test light connected to ground, backprobe IPC connector terminal A7 (Pink wire). See Figure . Turn ignition on. If test light illuminates, go to next step. If test light does not illuminate, go to step  7 .
  3. Connect test light between IPC connector terminals A7 (Pink wire) and A9 (Black/White wire). If test light illuminates, go to next step. If test light does not illuminate, go to step  6 .
  4. Using a test light connected to ground, backprobe IPC connector terminal A5 (Brown wire). If test light illuminates, go to step  8 . If test light does not illuminate, go to next step.
  5. Repair open, high resistance or short to ground in Brown wire between IPC connector terminal A5 and instrument panel fuse block. See WIRING DIAGRAMS  . Retest operation.
  6. Repair open or high resistance in Black/White wire between IPC connector terminal A9 and ground. See WIRING DIAGRAMS  . Retest operation.
  7. Repair open, high resistance or short to ground in Pink wire between IPC connector terminal A7 and instrument panel fuse block. See WIRING DIAGRAMS  . Retest operation.
  8. Replace IPC. See INSTRUMENT PANEL CLUSTER (IPC)  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals