LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Jimmy 2D Utility, 4WD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 300 (Disc Brakes & Drum Brakes) >> Adjustments & Inspections >> Park Brake >> Park Brake Inspection - Disc

Park Brake Inspection - Disc

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel.
  3. Remove the rear brake caliper bracket with the rear brake caliper. See BRAKE CALIPER BRACKET  under REMOVAL & INSTALLATION.
  4. Remove the rear brake rotor. See BRAKE ROTOR  under REMOVAL & INSTALLATION.
  5. Inspect the park brake shoe and lining. If it exhibits any of the following conditions, then it requires replacement :
    • Excessive wear indicated by the park brake lining being worn down to the shoe.
    • Brake lining cracking.
    • Oil or fluid contamination of the brake lining.
  6. Install the rear brake rotor. See BRAKE ROTOR  under REMOVAL & INSTALLATION.
  7. Install the rear brake caliper with the rear brake caliper bracket. See BRAKE CALIPER BRACKET  under REMOVAL & INSTALLATION.
  8. Install the tire and wheel.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals