LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> Jimmy 2D Utility, 4WD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 280 (Supplemental Inflatable Restraint System) >> Removal & Installation >> Steering Wheel >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Remove driver-side air bag module. See AIR BAG MODULES . Remove steering wheel horn contact by pressing inward to stop and rotating 90 degrees. Disconnect remaining steering wheel electrical connectors, if equipped. Remove steering wheel nut. Using Steering Wheel Puller (J-1859-A), remove steering wheel.
  3. To install, reverse removal procedure. Tighten steering wheel nut to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ZONE 3  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals