Section 1072 (Engine Mechanical - 4.8L, 5.3L & 6.0L (Repair Instructions - 3 Of 3))
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Repair Instructions (Off-Vehicle Repair Instructions Part 3)
- Engine Valley Cover Cleaning and Inspection
- Valve Rocker Arm Cover Cleaning and Inspection
- Oil Pan Cleaning and Inspection
- Intake Manifold Cleaning and Inspection
- Exhaust Manifold Cleaning and Inspection
- Coolant Air Bleed Pipe Cleaning and Inspection
- Water Pump Cleaning and Inspection
- Thread Repair
- Service Prior to Assembly
- Engine Prelubing
- Engine Block Plug Installation
- Crankshaft and Bearings Installation
- Piston, Connecting Rod, and Bearing Installation
- Camshaft Installation
- Timing Chain and Sprockets Installation
- Oil Pump, Pump Screen and Deflector Installation
- Engine Rear Cover Installation
- Crankshaft Rear Oil Seal Installation (without RPO HP2)
- Crankshaft Rear Oil Seal Installation (RPO HP2)
- Engine Front Cover Installation
- Crankshaft Front Oil Seal Installation
- Oil Pan Installation
- Oil Filter, Adapter, Pan Cover Installation
- Valve Lifter Installation
- Cylinder Head Installation - Left
- Cylinder Head Installation - Right
- Valve Rocker Arm and Push Rod Installation
- Valve Rocker Arm Cover Installation - Left
- Valve Rocker Arm Cover Installation - Right
- Engine Valley Cover Installation
- Coolant Air Bleed Pipe Installation
- Intake Manifold Installation
- Fuel Rail and Injectors Installation
- Throttle Body Installation
- Water Pump Installation
- Exhaust Manifold Installation - Left
- Exhaust Manifold Installation - Right
- Oil Level Indicator and Tube Installation
- Clutch Pilot Bearing Installation (without RPO HP2)
- Clutch Pilot Bearing Installation (RPO HP2)
- Engine Flywheel Installation
- Crankshaft Balancer Installation (without RPO HP2)
- Crankshaft Balancer Installation (RPO HP2)