LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2000 >> C3500 HD 6.5 F, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Mechanical - 4.3L V6, 5.0L, 5.7L & 7.4L V8 - VINS [W,X,M,R,J]) >> Removal & Installation >> Front Cover >> Installation

Front Cover: Installation

WARNING: This page does not describe the selected car, but rather 55 other vehicles, including the 1999 Oldsmobile Bravada, 1999 GMC Yukon, 1999 GMC Suburban, 1999 GMC Sonoma, and 1999 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
  1. On 4.3L, 5.0L and 5.7L, install NEW front cover and gasket. On 7.4L, front cover and front cover gasket are reusable. Replace only if damaged. Tighten front cover bolts to specification. See TORQUE SPECIFICATIONS .
  2. On all models, coat crankshaft front cover oil seal lips with clean engine oil. On 4.3L, 5.0L and 5.7L, install NEW seal in front cover with seal lip facing engine using Seal Installer (J-35468). On 7.4L, install NEW seal in front cover with seal lip facing engine using Seal Installer (J-22102).
    3. CAUTION: Ensure CKP sensor is fully seated and held stationary in bore of front cover upon installation. A CKP sensor that is not fully seated may result in erratic engine operation.
  3. Install CKP sensor. Tighten CKP sensor holddown bolt to specification. See TORQUE SPECIFICATIONS .
  4. Apply RTV sealant to Woodruff keyway in crankshaft damper. Install crankshaft balancer using Damper Puller/Installer (J-23523-F). Install crankshaft balancer bolt and tighten to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals