Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the Yukon Base, 4WD, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 2.2 | B | ||
| Front | 1.0 | 0.9 | B | |
| Rear | 1.4 | 0.9 | B | |
| Combination Procedure: AXLE BEARING: Replace: | ||||
| Rear,Both | 1.5 | B | ||
| Rear,One Side | 1.0 | B | ||
| Combination Procedure: AXLE SEAL: Replace: Semi-Floating Axle. | ||||
| Rear,Both | 1.3 | B | ||
| Rear,One Side | 0.9 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: | ||||
| Each Additional | 0.2 | B | ||
| One | Includes: Perform ABS Automated Bleed procedure. | 0.8 | B | |
| Combination Procedure: CALIPER: Overhaul: | ||||
| One | Includes: Perform ABS Automated Bleed procedure. | 0.9 | B | |
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Perform ABS Automated Bleed procedure. | 0.7 | B | |
| Combination Procedure: DISC ROTOR: Burnish Brake Rotors While Driving Vehicle: | ||||
| 0.5 | B | |||
| Combination Procedure: DRUM: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: WHEEL BEARING: Repack: Both Sides. | ||||
| 4WD, Front | Not Repackable. | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| 4WD, Front,One Side | 0.8 | B | ||
| Combination Procedure: WHEEL CYLINDER: Overhaul: | ||||
| One,Off Vehicle | Includes: Perform ABS Automated Bleed procedure. | 0.9 | B | |
| One,On Vehicle | Includes: Perform ABS Automated Bleed procedure. | 0.7 | B | |
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One | Includes: Perform ABS Automated Bleed procedure. | 0.7 | B | |