LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 1999 >> Forward Control 6.5 F, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Brake Caliper >> Installation

Front Brake Caliper: Installation

  1. Remove caliper sleeves from caliper. See Figure. Apply silicone grease to outer diameter of caliper sleeves and inner diameter of bushings. Insert caliper sleeves into bushings.
  2. Install retainer spring on inner pad (if removed). Install pads in caliper. Install caliper. Install guide pins and tighten to specification. See TORQUE SPECIFICATIONS .
  3. Connect brake hose to caliper and tighten to specification. See TORQUE SPECIFICATIONS . Bleed brake system. See MANUAL BLEEDING  or PRESSURE BLEEDING  under BLEEDING BRAKE SYSTEM.
  4. If outer pads are equipped with locking ears, bend ears toward caliper until ears touch caliper. This prevents movement of outer pad in caliper. See Fig 1. Install wheel.
Fig 1: Bending Outer Pad Ears Toward Caliper
G91I13506Courtesy of GENERAL MOTORS CORP.


  1. Using wire brush, clean corrosion from machined ways on caliper and caliper mount. Apply silicone grease to these surfaces. Install inner pad and anti-rattle spring on caliper mount. See Figure. Install outer pad in caliper. Place caliper on caliper mount.
  2. Install caliper support key and spring. Install caliper support key bolt, ensuring bolt boss fits into circular cutout on caliper support key. Tighten bolt to specification. See TORQUE SPECIFICATIONS .
  3. Connect brake hose to caliper and tighten hose bolt to specification. See TORQUE SPECIFICATIONS . Bleed brake system. See MANUAL BLEEDING  or PRESSURE BLEEDING  under BLEEDING BRAKE SYSTEM. Install wheel.
scientia non olet · About LEMON Manuals