Service Throttle Soon Indicator Inoperative (Diesel)
- Disconnect Powertrain Control Module (PCM) harness connector. Turn ignition switch to RUN position. Connect a fused jumper wire between White/Black wire terminal of PCM connector and ground. If indicator lights, problem is in throttle control system (accelerator pedal position sensor). See appropriate SELF-DIAGNOSTICS article in ENGINE PERFORMANCE. If indicator does not light, go to next step.
- Remove jumper wire. Using fused jumper wire, backprobe instrument cluster harness connector terminal No. 21 (White/Black wire) to ground. If indicator lights, repair open in White/Black wire. If indicator does not light, replace indicator.